Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem slightly old but it's appealing. It's not the most luxurious car in its class It's an Ford Focus or Volkswagen Golf will isolate you even better from imperfections on the road - but it's still a pleasant and comfortable driving experience.
We often receive requests from Coded Car Keys to replace peugeot key fobs. If the issue is intermittent or constant these tips will aid.
Water Damage
If you accidentally drop your key fob in a puddle, or if it is wet while kayaking, canoeing, rafting, or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry container whenever you go outside or engage in activities that could expose it to a lot of water.
It's also important to make sure that the fob is completely dried before you open the fob and then use it. If you detect any odors emanating from the fob (such as industrial fluid or windshield washer fluid), this is another indication that it's been submerged.
A wet circuit may cause the battery's power to be depleted or even explode. If you're able to pull the 308 key fob of whatever body of water it was stuck in, flip the button side down and shake out as much water as you can before opening the case. When you've opened it, remove the battery, and then clean the circuit board using a cotton swab dipped in 90-percent isopropyl alcohol.
Other reasons that your
peugeot 107 key programming 308 remote entry keyless system might not work include a dead battery in the coin-cell, receiver module problems, signal interference or a damaged chip. If none of these are the problem you can restart the system by removing the 12 voltage battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that allows drivers to start their car from an extended distance, which allows them to warm up or cool down the car prior to entering. This feature is extremely beneficial, especially during winter's cold and chilly months. Remote start systems may be stopped for a variety of reasons, such as the battery being dead.
The coin-shaped battery contained inside the key fob could last between two and four months, depending on the frequency with which it is used, where it was purchased, and the way it is utilized. The date of use is printed on the packaging or mentioned in the user's manual.
If the key fob stopped working after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. If the key fob was exposed to soapy or salty water, it may have fried the chip. It is necessary to replace it.
If you're not sure if the battery is defective it is possible to check its voltage using a multimeter that is connected to both the minus and plus terminals. The voltage should be around 12-13 volts however, if it reads lower, the battery needs to be replaced. Alternatively, you can try to reset the on-board computer by disconnecting the battery at 12 volts for a few minutes and then reconnecting it in reverse order (positive cable first and then negative). The engine should start after this.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, then it's possible the receiver module has been afflicted with a fault. It is the part that transmits an alert when the key fob activates. It also functions as an alarm and blocks the car from starting if it doesn't have the correct key.
The cause could be various factors, including water damage or simply aging. If the electronic chip inside your Peugeot 308 keyfob is damaged due to dirty tap water it could be because the keyfob was contaminated with it. In this scenario, you'll have to take it off and clean it thoroughly using isopropyl or electronic cleaner. Once the battery is dry, you can try again.
If the issue continues to persist, it's probably a good idea to visit a local
Peugeot Boxer Key Fob Programming specialist or locksmith. They'll be able to utilize a diagnostic tool to assist in identifying the problem and fix it.
It can be stressful to lose your Peugeot car key. However, a reputable auto locksmith can resolve the problem in minutes. They can cut a new key and program it to your vehicle, so you're out on the road as quickly as possible. Click here to find a locksmith near you.
Electronic chip that is malfunctioning
The electronic chip that is in the Peugeot 308 key fob plays a crucial function in the remote control system. If the chip is damaged, you may be unable to start your car or receive a message stating "anti-theft". If this occurs, the only way to fix the problem is to obtain a new key. Auto locksmiths who are professionals are able to offer the service within the shortest possible time.
The chip in the key fob of your
peugeot replacement key cost 308 could be damaged due to a variety of reasons, such as water damage, sweat or dirt. If your
peugeot 107 key fob not working 308 key fob is exposed to soapy water, clean it right away. You can wipe the electronic component using the help of a towel that is soaked in isopropyl Alcohol. The battery should then be allowed to completely dry.
Sometimes keys may stop working because of radio interference. This could be caused by other devices that operate at the same frequency as your
peugeot 307 key key fob. This could be due to bad conditions or objects close to the vehicle. It is recommended to visit a Peugeot dealer in the event of this issue.
The
peugeot 208 key fob Key Fob 207/308 is delicate and needs special care. It is imperative not to throw or drop the key fob. If you lose something, try to locate it as soon as you are able to. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Make sure you disconnect the negative cable first, then the positive.
