Peugeot 308 Key Fob Replacement
Peugeot's 308 might be somewhat old-fashioned but it's striking. It's not the most luxurious car in its class It's a Ford Focus or Volkswagen Golf will isolate you even better from imperfections on the road - but it's a relaxing and pleasant driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is intermittent or constant, the following tips should assist.
Water Damage
If you accidentally drop your key fob into a puddle, or if it is soaked while kayaking, canoeing, rafting, or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry, dry bag each time you go outdoors or do activities that expose it to excessive amounts water.
You'll also want to ensure that the fob is completely dry prior to opening it and re-using it. If you notice any odors coming from the fob, such as an industrial-type smell or a sour taste like windshield washer fluid, this is another indication that it's been submerged in water.
A circuit that is wet can cause the battery's power to be depleted or even explode. If you can pull your keyfob 308 out of the water it is best to turn the button side up and shake as much water out as you can prior to opening the casing. Take the battery out, and then wipe the circuit board clean using a cotton swab which is dipped in 90 percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system might fail to function include an empty coin battery or receiver module issue signal interference, an electronic chip that is defective. If none of these causes the cause, you can try resetting the system by disconnecting the 12 volt battery for approximately 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to stepping inside. This feature is extremely beneficial, especially in the cold winter months. Remote start systems may be stopped for a variety of reasons, including an inactive coin-battery.
The coin-shaped battery located inside the key fob will last between two and four years based on how often it's used, the location it was purchased, and how it is utilized. The use-by date will be written on the packaging or marked in the user manual.
If the key fob is not functioning after exposure to water that is clean, you should remove the battery, clean the electronic chip using a paper towel and isopropyl Alcohol, then dry it completely before replacing it. If you expose it to salty or soapy water, the chip could be fried and you will need to replace the key fob in total.
If you're unsure if the battery is faulty You can test its voltage with an instrument set to the vehicle's voltage range and connected to the plus and minus terminals. The voltage should be around 12 to 13 volts, but if it's lower, the battery should be replaced. If you want to, you can try to reset the on-board computer by disconnecting the battery at 12 volts for a few minutes, and reconnecting it in reverse order (positive cable first followed by negative). The engine should then start.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, it's possible that the receiver module has developed a fault. It's the part that sends an indication to the car when the key fob is activated, which also acts as an immobiliser. It stops it from starting unless the key that you want to use is present.
This can be due to several reasons, such as water damage or just aging. If your Peugeot 308 key fob has been exposed dirty tap water, as in the chip that is located on the inside will be damaged. In this situation, you'll need to take it out and thoroughly clean it using isopropyl or an electronic cleaner. Once the battery is dry you can attempt to test it again.
If the issue continues to persist, it is a good idea to consult the local
peugeot 3008 key fob programming expert or locksmith. They'll be able to use a diagnostic tool to identify the issue and fix it.
Losing your Peugeot car keys can be an extremely stressful experience. However, a reputable auto locksmith can resolve the problem in minutes. They can cut a brand new key and programme it to your vehicle, making sure you're ready to get on the road again as quickly as possible. Click here to find a local locksmith near you.
Faulty Electronic Chip
The electronic chip that is in the Peugeot 308 key fob plays a vital part in the remote control system. If it is damaged your car might not start, or you could receive a message stating "anti-theft active". In this scenario, the only solution is to replace the key. Auto locksmiths who are professionals can provide this service within the shortest possible time.
The chip in the key fob of your Peugeot 308 could fail due to a variety of reasons, such as sweat, water damage or dirt. If your
peugeot partner key replacement 308 key fob is exposed to soapy water, it is recommended to take it to the cleaners immediately. You can make use of a towel and isopropyl alcohol to clean the electronic component. The battery should be allowed to dry completely.
Radio interference can cause a key fob to stop functioning. This can be caused when other devices operate on the same frequency as your
peugeot 206 replacement Key keyfob. This could be due to unsafe conditions or objects that are in the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer if you encounter this problem.
The Peugeot 207/308 key fob is extremely delicate and requires special care. You should not drop it or throw it around. If you lose something, try to find it as soon as you can. You can reset your on-board computer by disconnecting the battery for a few minutes. Unplug the negative cable prior to the positive.